Drainage: If the existing drainage on your roof leaves large ponds on it after a rain, this must be addressed before the new roof is installed. If it is not addressed, the weight alone from a large amount of standing water will often cause structural damage to your building. Small ponds on flat roofs are normal and acceptable, large ones are not.

Scuppers: These are the objects that protrude through your parapet walls and your water runs through to get off the roof. Scuppers that are not sized properly or that are detailed incorrectly are very common causes of roof leaks.

Tie-In Areas: These are the areas where a flat and a pitched roof meet. This junction is a very common leak area. If only the flat portion of your roof is being done, a proper tie-in at the junction of your flat and pitched roof is critical to prevent leaks. In order for a proper tie- in to be performed, the flat roofing material must extend up the slope and under the pitched roofing material about 12 to 18 inches.

Roof to Wall Transitions: This is one of the most common areas where leaks can actually be CREATED by the roofer. In the case of a framed building with stucco, while installing a foam roof, there are very specific ways in which wall to roof transitions must be performed. Watch our videos to learn more about this.